Skip to main content

HVAC Emergency? Get Service

Warm Air From The Vents? Book An AC Repair

Book Ahead Of The Big Breakdown

Mini-Split And Ductless Service

Somerset Residential and Commercial HVAC Contractor

When the heat stops working or the air conditioning gives out, the call that gets things moving is the one to us. We cover the full range of residential and commercial heating and cooling work in Somerset: AC repair and service, furnace repair, heat pump installation and service, boiler work, ductless mini-splits, ductwork, thermostats, indoor air quality, seasonal maintenance, and emergency HVAC calls. The price for a diagnostic visit is given on the phone before anything is scheduled, and the diagnosis is explained before any repair is authorized.

Somerset is a town where a lot of the housing stock was built well before modern HVAC equipment was standard. That means older boilers still running on oil heat, homes without central ductwork, and additions that the original heating system never quite reached. We work on all of it. Commercial rooftop units are covered as well as residential, so building owners and property managers in town have the same call to make. We are available every day from 8:30 AM to 11:00 PM.

Call (401) 535-9789 for a quote.

What a Scheduled Visit Does for the Property

A tune-up is not just a filter swap. A seasonal maintenance visit covers the components most likely to cause a failure when the system is running hardest: refrigerant charge on a cooling system, heat exchanger condition and burner operation on a furnace, circulator pump and zone valve function on a boiler, and electrical connections and safeties across the board.

Before the Cooling Season

A spring AC check covers the evaporator coil, condenser coil, refrigerant pressure, and blower operation. A marginal refrigerant charge found in May costs far less to address than an emergency call in the middle of a humid July. Thermostat calibration is part of the visit too, because a control that is reading a degree or two off makes the whole system work harder than it needs to.

Before the Heating Season

A fall heating check on a furnace covers the heat exchanger, ignition system, gas valve, and condensate drainage. On a boiler, it means system pressure, zone controls, and the circulator. Catching a failing igniter or a partially blocked heat exchanger in October is a different situation from finding the same fault at ten at night in February. Maintenance does not guarantee the system runs perfectly, but it gives you the best picture of what you are heading into. Clear notes on what was found and what was done come with every visit.

Repair Against Replacement: The Real Calculation

Some repairs make obvious sense. A failed capacitor on an otherwise sound air conditioner is a straightforward fix, and the system runs well afterward. The calculation gets harder when the repair is significant and the equipment is already well into its service life.

When Repair Is the Right Answer

A system that has been maintained, is not losing efficiency noticeably, and has a fault that is isolated to one component is usually worth repairing. The cost of the repair relative to what a replacement system would run is the practical question, and that answer comes after the diagnostic, not before it.

When the Money Gets Spent Twice

A heat exchanger failure on a furnace that has already had significant work done, or a compressor failure on an aging AC unit, often shifts the math. Running a system that is losing ground on efficiency while accumulating repair costs means paying twice: once for the repair and again for the replacement that was coming anyway. The age of the system changes the answer, and that gets said. We do not recommend replacement without the diagnostic findings in front of both parties.

Somerset And The Towns Either Side

Getting Somebody Out to Somerset When It Matters

Emergency HVAC calls are answered every day from 8:30 AM to 11:00 PM. No-heat calls in the middle of winter and no-cool calls during a heat stretch are both handled within those hours. The job is scoped on the phone before the visit, so the technician who comes out arrives prepared rather than starting from scratch.

For rental properties and businesses that cannot simply shut down and wait, that preparation matters. Knowing what the system is doing, what equipment is involved, and what access looks like before the visit means less time on site working out the basics. We do not promise a specific arrival window, but emergency calls are answered and the scope is confirmed on the call.

Appointments for non-emergency work are arranged the same way: call, describe the system and the symptoms, get the price for the visit, and confirm the schedule. During peak season, booking a few days ahead is common. For a tune-up before the heating or cooling season, calling a week or two out is the practical approach. Most of the practical detail sits on our list of HVAC services.

Maintenance Visits And Repairs - Call

What the System Is Doing That Brought You Here

Ductwork for an Addition or a Space That Never Got Comfortable

Older Somerset homes were often built without central ductwork, and additions are rarely connected to the existing distribution system in a way that actually works. Ductwork design for an addition involves sizing the new branch runs to the air handler's capacity, not just running whatever fits through the available space. A room that is always too hot or too cold is often a duct problem before it is an equipment problem.

Heat Pump Installation and Replacement

A heat pump handles both heating and cooling from a single system. In a region pushing toward electrification, it is also the path away from oil heat for homes that want to move off fuel delivery. Installation involves sizing the unit to the space, confirming the existing distribution system can work with it, and for homes in real New England winters, often pairing it with supplemental backup heat. Replacement follows the same scoping process: the existing system is assessed before a unit is selected.

Water Pooling Around Indoor Equipment

Standing water near an air handler or furnace is not a plumbing problem. The condensate line that carries moisture away from the evaporator coil can become blocked, which causes water to back up and pool around the unit. Left alone, it damages equipment and the surrounding structure. A service call covers clearing the drain, checking the condensate pan, and confirming the line is running freely.

Full System Replacement

When both the heating and cooling equipment need to go, a full replacement involves selecting matched components, confirming the ductwork can support the new system's airflow, and completing the installation to code. Permits are handled where the job needs them. The scope and the price are settled before work starts.

Air Filtration and Indoor Air Quality

A whole-home air filtration system works through the existing air handler rather than as a standalone unit, which means it conditions the air every time the system runs. UV air purifiers and air scrubbers address different problems: biological material in the air stream versus odors and volatile compounds. What makes sense depends on what is actually happening in the space. Zoning and comfort-control systems are part of this conversation too, since an older home with one thermostat controlling the whole house is often uncomfortable in ways that better air distribution can address directly.

Book A Ductwork Check Before A Remodel

How the Price Gets Settled

The price for the diagnostic visit is confirmed on the phone before anything is scheduled. That covers the visit itself. A repair quote comes after the diagnostic, once the technician has inspected the equipment and identified the fault.

What moves a repair quote up or down is the component that has failed, the age and type of the equipment, and whether the system has secondary issues the original symptom was masking. A refrigerant leak diagnosis, for example, involves finding the leak before quoting the repair, because the location affects how the job is done and what it costs. Nothing is added to the scope without your agreement first.

For installation and replacement work, the quote covers the equipment and the installation scope together. Ask what is included and you get a straight answer. The price is agreed before work starts. One call. One clear diagnosis. One price, agreed first.

When You Are Somewhere Near Somerset, We Cover That Too

We serve Somerset and the surrounding towns throughout Bristol County. Neighboring communities we cover include Swansea, Fall River, Warren, North Westport, and Ocean Grove.

If you are just outside Somerset and are not sure whether we reach your address, call (401) 535-9789 and we will tell you directly.

No Guesswork On Price - Call

Your Top Questions Answered

Can a landlord put several properties on a regular maintenance arrangement?

Yes. If you manage multiple properties and want them all serviced on a regular schedule, call us and we will work out what that looks like. The scope, frequency, and pricing for each property are confirmed on the call, and the arrangement is built around what the properties actually need rather than a fixed package.

Older homes in this part of Bristol County often run on hot-water boilers with radiators, and oil heat is still common throughout the area. We work on all of it: gas and oil furnaces, hot-water and steam boilers, heat pumps, and ductless mini-split systems. If you are not sure what type of system you have, describing what you see on the call is usually enough to get the visit scoped correctly.

Yes. The job is scoped on the call so the technician who comes out knows what to expect before arriving, which keeps the visit focused and the disruption short. For occupied rentals, letting us know on the call that the unit will be occupied means the visit can be planned around that from the start.

A ductless mini-split system is the most practical path for a home without existing duct runs. It delivers heating and cooling directly to a room or zone through a wall-mounted air handler connected to an outdoor unit, with no ductwork required. Multi-zone systems can condition several rooms independently from a single outdoor unit, which makes them a good fit for older homes where adding full ductwork is not practical.

A Property That Has Not Been Comfortable for a While

That is usually where the call starts: a house that has been too cold in one room for two winters, a system that has been limping along and finally stopped, a boiler that nobody has looked at in years. The call is the point where that changes.

Call Cranston HVAC Company at (401) 535-9789.

We take calls every day from 8:30 AM to 11:00 PM, and the price is given before anything is scheduled. We're ready to get your heating and cooling running again.

HVAC service covers these nearby towns as well: Swansea, Warren, Bristol, Barrington, Rehoboth.

There is more on our coverage area.

HVAC Services in Plain Terms

Whether the call is about a furnace that stopped firing, an AC that is running but not cooling, or a full system replacement, we handle the complete range of heating and cooling work for homes and commercial properties across Somerset and Bristol County. The table below lays out what each service covers, who it fits best, and what is useful to know before you call. If you have a question that is not answered here, call us and we get into the specifics with you directly.

HVAC ServiceWhat It CoversWhen You Need ItGood to Know
Heat Pump Repair & ServiceRefrigerant circuit diagnosis, Reversing valve check, Control board testing, Efficiency and output verificationProperties with an existing heat pump that is not reaching temperature in heating or cooling modeA heat pump that heats in summer and cools in winter has a reversing valve that can fail in one direction only, which is a common diagnostic finding.
Ductwork Repair & SealingLeakage diagnosis, Disconnected section repair, Duct sealing and insulation, Full ductwork replacement where neededForced-air homes where the system runs long, rooms are uncomfortable, or energy costs are climbing without an obvious equipment causeConditioned air escaping into an attic or crawl space before it reaches the living area is one of the most common reasons a system underperforms, and it shows up on the energy bill before anything else.

Call (401) 535-9789 to talk through your heating or cooling situation and get a price before anything is scheduled.

Talk It Over Before Booking

(401) 535-9789