Skip to main content

HVAC Emergency? Get Service

Warm Air From The Vents? Book An AC Repair

Book Ahead Of The Big Breakdown

Help With Breakdowns And Emergencies

Scituate Residential and Commercial HVAC Contractor

When something stops working, the first question is almost always whether the system can be repaired or whether it has to go. That answer depends on what the equipment is doing, how old it is, and what the diagnostic turns up. We come out, look at what is actually happening, and give you a clear picture before any work is authorized.

We cover the full range of heating and cooling work in Scituate: furnace and boiler repair, AC service, heat pump installation and repair, ductless mini-split installation, ductwork, thermostats, indoor air quality, and emergency calls. Homes in this part of Providence County tend to run older equipment, and a lot of them heat with oil or hot water. That is the work we do here.

Call (401) 535-9789 to get started.

Right-Sizing a Replacement

A replacement is not simply swapping what was there for the same thing in a newer model. The old unit may have been the wrong size for the house to begin with, or the house may have changed since it was installed. A finished basement, a converted attic, or an addition that was never properly connected to the distribution system all affect what the new equipment needs to do.

Sizing is done by calculating the actual heating and cooling load for the space, not by matching the capacity number on the old unit. An oversized system short-cycles, running in short bursts that never properly condition the air and that wear components faster than a correctly sized unit would. An undersized system runs continuously without reaching setpoint. Getting the load calculation right before selecting equipment is the step that determines whether the replacement actually solves the problem.

That conversation happens on the call and continues during the site visit. The price and the scope are confirmed before anything is ordered.

How a Quote Comes Together and What Can Change It

The price for a service call is confirmed before it is scheduled. What happens after the technician arrives depends on what the diagnostic finds, and that is where the repair or replacement quote is built.

A few things move the number in either direction. The fault itself matters: a failed capacitor is a straightforward fix, while a refrigerant leak that has been running for a season may have caused secondary damage to the compressor or the coil. Access matters too. A system installed in a tight crawl space or an attic with limited clearance takes longer to work on than one in an open mechanical room. And the repair-versus-replace question matters. On an older system, a repair that costs a significant portion of what a new unit would run is worth examining carefully before committing to it.

The diagnosis is explained before any repair is authorized. You get a clear account of what was found and what fixing it involves, and you decide whether to proceed. Call us and we'll walk you through your options.

In Scituate, Or On The Outskirts?

When the Property Needs Help Now

We take calls every day from 8:30 AM to 11:00 PM, including weekends. Emergency calls, whether that is a boiler that stopped overnight, an AC that failed during a stretch of humid summer weather, or a heat pump that is running but not producing any heat, are answered within those hours. The job is scoped on the call so the visit is prepared before anyone arrives.

Rental Properties and Occupied Buildings

A tenant who has no heat or no cooling cannot wait for a convenient scheduling window. We work around occupied properties and can discuss timing on the call. The scope and the price are settled before the visit is confirmed, so there are no open questions by the time the technician arrives.

Scheduling Routine Work

For seasonal tune-ups and non-emergency repairs, calling a few days ahead is usually enough outside of peak season. In the weeks before summer and at the start of heating season, lead times stretch. Getting preventive maintenance scheduled before the system is needed most is the straightforward way to avoid that crunch.

Ductwork: The Hidden Load

Leaking or poorly run ductwork is one of the most common reasons a system underperforms without any obvious fault in the equipment itself. When conditioned air escapes into an attic, a wall cavity, or a crawl space before it reaches the room it was meant for, the system runs longer, the house stays uncomfortable, and the energy cost climbs without any visible explanation.

Duct sealing and repair addresses the leaks directly. In older homes where the ductwork was run without much attention to airflow balance, we also look at whether the distribution system is reaching the spaces that need it. A room that is always too cold in winter or too warm in summer is often a duct problem before it is an equipment problem. Fixing it does not require opening walls. Most of the accessible leakage is at joints, connections, and the points where ducts meet the air handler or the registers. If you are still deciding, our list of heating and cooling services may help.

Noisy, Leaking Or Dead? Call

What Gets the System Running Again

Ignition and Flame Sensor Faults

A furnace that fires and then shuts off before the house reaches temperature is often a flame sensor problem. The sensor reads the burner flame and shuts the system down if it does not detect one. When the sensor is coated with residue, it stops reading correctly even when the burner is working. The fix is usually straightforward, but a system that keeps repeating the fault may have a deeper ignition or gas valve issue that the sensor fault was masking.

Evaporator Coil Cleaning and Repair

The evaporator coil sits inside the air handler and is where the refrigerant absorbs heat from the indoor air. A coil that has accumulated dust and debris cannot transfer heat efficiently, which means the system runs longer without producing the cooling the thermostat is calling for. In a worse case, restricted airflow across a dirty coil causes the refrigerant to drop below freezing and the coil to ice over, which blocks airflow entirely. Cleaning the coil restores the heat transfer surface. If the coil itself has corroded or cracked, repair or replacement is the next step.

Refrigerant Leak Diagnosis and Repair

A system that is low on refrigerant is not simply a matter of topping it off. Refrigerant does not get consumed in normal operation, so a low charge means there is a leak somewhere in the circuit. Adding refrigerant without finding and fixing the leak is a temporary measure that delays the real repair and can damage the compressor over time. We locate the leak, repair it, and then restore the charge to the correct level. All refrigerant work is carried out to code.

Systems That Short Cycle On and Off

A system that turns on and shuts off every few minutes without completing a full heating or cooling run is short-cycling, and it puts significant stress on the compressor and other components. The causes vary: an oversized unit that satisfies the thermostat almost immediately, a refrigerant charge problem, a dirty filter restricting airflow, or a control board fault. Identifying which one applies is what the diagnostic is for. Running a short-cycling system without addressing the cause accelerates wear and leads to a larger repair further down the line.

Real experience. Local knowledge. Comfort is the job.

Book Now And Get The AC Running

Where We Work in Scituate and the Surrounding Area

We serve Scituate and the communities around it throughout this part of Providence County. That includes Clayville, Foster Center, Foster, Johnston, and Harmony. If you are in one of those towns or in the area between them, we cover your address.

You're talking to someone who knows the area and the systems in it. Homes here vary from older houses still on original oil-fired equipment to newer construction with heat pumps, and the range of work reflects that.

Call (401) 535-9789 and we will confirm coverage for your address on the spot.

Clear Pricing Up Front - Call

Answers to the Questions We Hear Most

If I want to move away from oil heat, what are the realistic options for a home in this area?

The two most common paths are a conversion to natural gas, where utility service is available, and a heat pump conversion, which runs on electricity. A hybrid system that pairs a heat pump with a gas or oil backup is also an option for properties where the heating load in the coldest weeks exceeds what a heat pump alone handles efficiently. The right answer depends on the home, the existing distribution system, and what the property already has in place. That conversation starts on the call and continues with a site assessment before any recommendation is made.

Once a year is the standard for most systems, and twice a year is reasonable if the property runs both heating and cooling heavily. A spring visit before the cooling season and a fall visit before the heating season each catch the issues most likely to cause a failure in the coming months. The frequency can be adjusted based on the age and condition of the equipment.

Homes in this part of Providence County run a wide range of equipment: oil-fired furnaces and boilers, gas furnaces, hot-water radiator systems, and heat pumps are all common. We work on all of them. If you are not sure what type of system you have, describe what you see when you call and we can help identify it before the visit.

Call to Get the Job Scoped

When you call, we ask about the equipment, the symptoms, and the property. By the end of the call you will have a confirmed price for the service visit and a scheduled time.

Call Cranston HVAC Company at (401) 535-9789, available every day from 8:30 AM to 11:00 PM.

One call. One clear diagnosis. One price, agreed first.

Just as close, we take heating and cooling work in: Johnston, Greenville, Coventry, Smithfield.

There is more on our coverage area.

HVAC Services in Plain Terms

Whether the call is about a furnace that stopped firing, an AC that is running but not cooling, or a full system replacement, we handle the complete range of heating and cooling work for homes and commercial properties across Scituate and Providence County. The table below lays out what each service covers, who it fits best, and what is useful to know before you call. If you have a question that is not answered here, call us and we get into the specifics with you directly.

HVAC ServiceWhat It CoversWhen You Need ItGood to Know
Heat Pump Repair & ServiceRefrigerant circuit diagnosis, Reversing valve check, Control board testing, Efficiency and output verificationProperties with an existing heat pump that is not reaching temperature in heating or cooling modeA heat pump that heats in summer and cools in winter has a reversing valve that can fail in one direction only, which is a common diagnostic finding.
Thermostat Installation & Smart ControlsProgrammable and smart thermostat installation, Air handler communication check, Setpoint calibration, Control wiring on the equipment sideAny home or commercial property where the existing thermostat is not holding temperature or communicating correctly with the systemA thermostat that is reading temperature incorrectly can make a functional system behave as though something is wrong. Replacing it is often the lowest-cost fix on the list.

Call (401) 535-9789 to talk through your heating or cooling situation and get a price before anything is scheduled.

Let Us Know What You Need

(401) 535-9789