Home » Service Areas » Portsmouth
Portsmouth and the communities surrounding it sit on some of the oldest housing stock in the region. Many homes here were built before central ductwork was standard, and a large share still run on boilers, hot-water radiators, or oil heat. When the heating system stops working in January or the air conditioning can't keep up in July, the call needs to reach someone who understands what is actually in the house. That is the work we do here.
We cover Portsmouth and the nearby communities of Middletown, Tiverton, Bristol, Newport East, and Melville. Heating repair, AC repair, heat pump service, boiler work, ductless mini-split installation, system replacement, ductwork, thermostats, and emergency calls are all part of what we handle. We take calls every day from 8:30 AM to 11:00 PM.
Call (401) 535-9789 to get a quote.
Replacing a whole heating and cooling system is not a same-day decision. Before anything is ordered, the job has to be scoped: what equipment the house currently has, what the distribution system looks like, whether the existing ductwork or hydronic piping can support the new unit, and what size system the space actually requires. Undersizing a replacement unit means it runs constantly without reaching temperature. Oversizing it means it short-cycles and never properly dehumidifies the space. Both outcomes show up on the energy bill and in daily comfort.
For homes converting from oil heat to a heat pump or a gas-fired system, the scoping conversation is longer. The existing fuel system has to be removed, the new equipment has to connect to whatever distribution infrastructure is already there, and in some cases that infrastructure needs work before the new unit is installed. All of that gets confirmed on the call before anything is scheduled.
A straightforward equipment swap on a forced-air system, where the ductwork is intact and the new unit is in stock, is typically a single-day job. A conversion from oil to gas or a full heat pump installation in a home that currently has no ductwork takes longer. The technician who comes out will give you a realistic picture of the timeline after assessing the space. What we can say on the call is what the scope looks like and what the price covers.
Permits are handled where the job needs them, so a replacement does not stall on paperwork partway through.
A retail space, a restaurant, or any commercial property that cannot simply close for the day needs a different approach from a residential job. When the heating or cooling system in a commercial space fails, the impact is immediate: staff and customers feel it, and in some cases the space cannot legally operate without it. We take commercial HVAC calls on the same schedule as residential ones, every day from 8:30 AM to 11:00 PM, and the job is scoped on the call so the visit is prepared before anyone arrives.
For larger commercial jobs, staging the work in phases is sometimes the right answer. A rooftop unit serving one zone can often be taken offline while the rest of the building stays conditioned. The scope of what is possible gets worked out on the call, not on the day of the visit.
Commercial rooftop units are covered as well as residential systems. A rooftop unit has different failure modes from a split system, and diagnosing one correctly means checking the economizer, the heat exchanger, the refrigerant circuit, and the controls as a system rather than in isolation. Multi-zone commercial systems, where individual thermostats control separate areas of the building, add another layer to the diagnostic when one zone is out but others are not.
The price for a service call is given on the phone before anything is scheduled. What the repair costs on top of that depends on what the diagnostic turns up, and that is not something any honest quote can pin down before the system has been looked at.
Several things move the number. The part that has failed matters: a capacitor and a compressor are not in the same range. What has to be accessed matters too. A component buried inside an air handler in a tight mechanical room takes longer to reach than one mounted on the exterior unit. And the repair-versus-replace question changes the answer entirely. If the diagnostic reveals a heat exchanger crack in a furnace that is already old, the conversation shifts from repair cost to replacement cost, and the quote reflects that.
You get the price before any work begins. The diagnosis is explained before any repair is authorized. Ask what the quote covers and you get a straight answer.
When a Portsmouth home or business loses heat in the middle of winter or loses cooling during a stretch of humid summer weather, waiting until a convenient appointment slot is not an option. We take emergency no-heat and no-cool calls every day from 8:30 AM to 11:00 PM. The job is scoped on the call so the visit is set up correctly before anyone heads out.
For tenants and occupied rental properties, we understand the situation is not just about the equipment. A rental unit without heat is a landlord's problem as much as a tenant's, and the call gets treated accordingly. The diagnostic is explained, the repair is quoted, and nothing starts without sign-off.
We do not promise a specific arrival window, but emergency calls are answered and the situation is assessed on the phone. You will know what to expect before the visit happens. What the work involves is covered on our list of HVAC services.
A heat pump that stops heating in cold weather is not always a refrigerant problem. The defrost cycle, which clears ice from the outdoor coil in low temperatures, can fail in ways that cause the system to run constantly without producing useful heat. A defrost board fault, a stuck reversing valve, or a defrost sensor that has drifted out of calibration can all produce the same symptom. Diagnosing which one is the issue requires checking the refrigerant circuit alongside the control components.
A system that turns on and off every few minutes without completing a full heating or cooling run is short-cycling, and it puts wear on the compressor and blower that accumulates quickly. The cause is often a restricted filter or coil, a refrigerant charge problem, or an oversized system that reaches the thermostat setpoint before the air in the space has properly mixed. Vent and register rebalancing addresses the distribution side of the problem: when some rooms are overcooled and others are not being reached, adjusting dampers and register positions can correct the imbalance without touching the equipment itself.
An AC system that runs continuously without bringing the indoor temperature down is one of the more common summer calls. The most frequent causes are a low refrigerant charge from a slow leak, a dirty evaporator coil that cannot absorb heat efficiently, or a condenser coil outside that is blocked with debris and cannot reject heat to the outdoor air. Refrigerant leak diagnosis involves checking the system pressure and tracing the leak to its source before any refrigerant is added. Adding refrigerant to a leaking system without finding the leak means the same call happens again in a season or two.
When the system is running but little air is coming out of the registers, the problem is usually in the air handler or the ductwork rather than the refrigerant circuit. A failing blower motor, a collapsed duct section, or a filter so restricted it has cut airflow to near zero are the first things to check. In older homes where ductwork was added after the fact, disconnected or undersized duct runs are a common finding.
We serve Portsmouth and the surrounding Newport County area, including Middletown, Tiverton, Bristol, Newport East, and Melville.
If you are in a part of the county not listed here and are not sure whether we cover your address, call (401) 535-9789 and ask. We will tell you directly.
You're talking to someone who knows the area and the systems in it. The housing stock across Newport County ranges from historic homes that have never had central air to newer construction with fully ducted systems and smart controls. The diagnostic approach changes depending on what is actually in the house, and knowing what to expect before the visit saves time on both ends.
Call us at (401) 535-9789 and describe the system and the symptoms.
We take emergency no-heat and no-cool calls every day from 8:30 AM to 11:00 PM, and the job is scoped on the phone so the visit is prepared before anyone arrives. The diagnostic findings are explained before any repair is authorized, so you know exactly what the repair covers and what it costs before work begins.
The job starts with scoping the existing system: what the oil equipment is, what the distribution system looks like, and whether the current piping or ductwork can support a heat pump. The old oil equipment is removed, the new heat pump is installed and connected to the distribution system, and in many cases a supplemental backup heat source is included for the coldest stretches of a New England winter. Permits are handled where the job needs them, and the full scope and price are confirmed before anything is scheduled.
A maintenance visit includes checking the filter and noting its condition. Whether it is changed during the visit depends on whether a replacement is needed and whether the customer supplies the filter or wants one sourced as part of the visit. That detail is confirmed when the visit is booked.
Older homes in the area were often built without central ductwork, which means a forced-air replacement is not always a straightforward swap. Ductless mini-split systems and hydronic heating upgrades are practical options for homes where running new ductwork would be disruptive or cost-prohibitive. The right answer depends on what distribution infrastructure is already in the house, and that gets assessed as part of the diagnostic or installation scoping call.
The call is where the job starts. We will ask about the equipment, what it is doing or not doing, and what kind of property it is in. By the end of the call, you will have a price for the service visit and a scheduled appointment.
Call (401) 535-9789, available every day from 8:30 AM to 11:00 PM.
One call. One clear diagnosis. One price, agreed first.
Other towns where we take heating and cooling work: Bristol, North Kingstown, Warren, Barrington.
View our coverage area.
Whether the call is about a furnace that stopped firing, an AC that is running but not cooling, or a full system replacement, we handle the complete range of heating and cooling work for homes and commercial properties across Portsmouth and Newport County. The table below lays out what each service covers, who it fits best, and what is useful to know before you call. If you have a question that is not answered here, call us and we get into the specifics with you directly.
| HVAC Service | What It Covers | When You Need It | Good to Know |
|---|---|---|---|
| Full System Installation & Replacement | Equipment sizing and selection, Removal of existing system, Full installation and commissioning, Permits handled where the job needs them | Homeowners and property managers whose existing equipment has reached end of life or requires a repair that no longer makes financial sense | Installation scope and pricing are confirmed before work starts. The quote covers the equipment and the job, and the diagnosis is what drives the recommendation, not a default position. |
| Heating & Furnace Repair | Ignition system diagnosis, Heat exchanger inspection, Gas valve and burner check, Blower motor testing | Any property with a forced-air furnace that is underperforming or not firing | A furnace that short-cycles or blows cold air usually points to a specific component fault, not general wear, and the diagnosis identifies which one before any repair is authorized. |
| Seasonal Maintenance & Tune-Ups | Refrigerant charge verification, Coil cleaning and inspection, Heat exchanger and burner check, Safety and thermostat calibration | Homeowners, landlords, and property managers who want to catch problems before the heating or cooling season begins | A marginal capacitor or a partially blocked heat exchanger found in October costs far less to address than an emergency call in February. |
Call (401) 535-9789 to talk through your heating or cooling situation and get a price before anything is scheduled.